How the machine senses brew temperature
The machine doesn't measure the water in your cup. It measures one spot. Usually that's where a small sensor has been fitted. Every number on the display starts from that single reading.
What a typical sensor is
Short answer: often a thermistor.
Electronic temperature controls often use a thermistor. Wikipedia describes it as a "type of resistor whose resistance varies with temperature". The controller reads that resistance and converts it to degrees.1
There are two kinds, NTC and PTC. With a negative-temperature-coefficient (NTC) thermistor, resistance falls as the temperature rises. The source says NTC thermistors are "widely used as inrush current limiters and temperature sensors".1
Thermostats use sensors too. Mechanical ones commonly use bimetallic strips. Electronic ones use "a thermistor or other semiconductor sensor".2
Which one does your machine use? This page can't say. Your manual or the maker's support page might.
Where the sensor sits matters
The reading belongs to wherever the sensor touches, and that might be the metal of the boiler or the water inside it, depending on how the maker built the machine. A reading taken at the portafilter or in the cup is a different thing, and it needs a different sensor.
Home machines differ in how they heat water. Wikipedia says "four variants exist in home machines, depending on how brew water and steam are boiled".3
| Layout | A question for the manual |
|---|---|
| One boiler for brewing | Is the sensor on the boiler wall or in the water? |
| One boiler, brewing and steam | How does the target change between the two jobs? |
| Heat exchanger | Is the reading the boiler's or the brew water's? |
| Two heaters | Which heater does the displayed number belong to? |
Heat exchanger machines are the clearest case. Wikipedia explains that their brew water comes from steaming temperature rather than being kept at brewing temperature. That makes it indirect. A reading from the boiler can sit one step away from the water you drink.3
The other rows of the table are questions, not claims. They show what a sensor at the boiler can and can't know. They don't describe every model, so put each one to your own manual.
Questions to ask about your machine
Not every manual spells out the sensor, and some show nothing more than a display and a setting, which leaves you guessing about what that number really describes. If yours is silent, ask the maker's support team a few plain questions:
- Where is the temperature sensor fitted?
- Does the display show the boiler, the brew water or something else?
- Is the displayed value adjusted by the machine in any way?
Support teams can answer those. A forum guess can't speak for your exact model.
What follows
A sensor reading is only as useful as the place it's taken. That's why the shown temperature and the water in the cup needn't match. The display-versus-cup page takes that up. And the PID basics show how the reading is used.
Cited material
- Thermistor, Wikipedia
- Thermostat, Wikipedia
- Espresso machine, Wikipedia