Why the display number is not the water in the cup
The display shows what the sensor reads. Not the water meeting the coffee. Between the two sit other parts of the machine, and some makers say so outright in their guides.
Three reasons the numbers can differ
Here they are.
First, the sensor reads one spot. This is a general explanation, not something a saved source states. Check your own manual to see where your machine's sensor sits.
Second, parts between the boiler and the coffee. One maker's setup guide gives about 7-8 minutes for the PID to reach 93C. It then adds a further 5 minutes for the group head. That extra wait is the maker saying the display isn't the whole story.1
Third, the machine's layout. Take the heat exchanger type. Its brew water is "indirectly converted from steaming temperature to brewing temperature", says Wikipedia. It also says the type "requires a cooling flush of 4–6 seconds" first.2
Some machines share one chamber for brewing and steam. Wikipedia describes them as "requiring a warm up period" between pulling a shot and frothing milk. The heat has to change as the job changes.2
Side by side
| Situation | What the display tells you | What it can't tell you |
|---|---|---|
| Heat exchanger machine | A temperature reading. Whether it is the boiler or the brew water is for your manual or the maker to say | Brew water that is indirectly converted from steaming temperature, so a boiler reading may not be the brew water's2 |
| Machine still warming | The boiler has reached its set value | Whether the group has caught up1 |
| Machine under heavy use | The target you set | How quickly the controller recovers from a big disturbance3 |
What to do with this
Treat the set value as a target. It says what the controller is aiming for, which is a different matter from what's happening inside the group head or at the coffee. Follow the warm-up steps in your own manual, and if the manual names a wait after "ready", take it seriously.
Don't borrow a number from a forum or a friend's machine. A setting that suits one layout can be wrong for another.
A short checklist for your own machine
- Find out what the display shows: boiler, brew water or something else.
- Read the warm-up note in the manual. Look for any wait after the ready signal.
- Note whether your layout shares one chamber for brewing and steam.
- Check the maker's support page before you assume a fault.
Small steps like these beat any single figure, because they keep you tied to the maker's own description of the machine you actually own. Simple.
No saved maker's manual gives a figure for the gap, so this page doesn't either. If your maker publishes one, use that.
Two more pages help here. The warm-up page covers what makers say about waiting. The settings page covers changing the target.
Cited material
- LUCCA Solo: Setup Guide, Clive Coffee Help Center
- Espresso machine, Wikipedia
- Proportional–integral–derivative controller, Wikipedia